When it comes to car maintenance, every driver can talk a few words. Everyone wants their car to be beautiful and of superior quality. In the long journey, due to mechanical wear, natural corrosion and other reasons, the technical performance of the car will be reduced. If the long-term lack of necessary maintenance will not only shorten the life of the car itself, it will also become a major hidden danger that affects traffic safety. So let’s take a look at what little tricks can help us?
(1): How to eliminate the vibration and noise of the wiper blade: Use pliers to reduce the gap between the joints and the rubber sheet.
(2): How to extend the life of the bulb: After buying a car or replacing a new bulb, wipe the bulb with alcohol to eliminate fingerprints and oil stains. I did this after buying a car, and a light bulb hasn't broken so far.
(3): How to reduce tire noise: just stick a layer of black felt or flannel on the inner protective plate of the front wheel. (Carefully understand that the noise of your tires becomes smaller after the rain, and becomes louder after washing the car, because there is mud on the inner protective plate to absorb noise)
(4): How to eliminate the noise caused by uneven wear of individual tires: After four-wheel alignment and balancing, look for a bicycle to be repaired. Borrow or buy a wooden file to smooth out the unevenness of the tread.
(5): How to extend the service life of the muffler: Punch a small hole at the lowest point under the muffler. The reason is simple: drainage is anti-corrosion.
(6): How to start and speed up quickly: When the vehicle is empty or less loaded, start directly with the second gear (don’t worry about damage to the vehicle, because the first gear and clutch are designed for heavy loads, and Most cars do not change smoothly from first gear to second gear). After rushing to more than 3,000 rpm, quickly push into third gear, and then rush to more than 3,000 rpm. At this time, the general car will be behind you, so you can switch between fourth and fifth gears calmly. It can also be directly shifted to fifth gear (applicable to highway tolls) without increasing fuel consumption. Give it a try.
(7): Simple handling of car shake in the morning: Because individual cylinders are not working well and the valve is not closed tightly, running at high speed is one way (fee silver), and you can also run at high speed in 3 or 4 gears for a while (Save gold), the effect is the same. If the hot car does not shake but the gear shift is not smooth (hand gear), it may be due to uneven fuel injection from the fuel injector, which needs to be tested and cleaned.
(8): How to prevent the antenna from being stolen: Unscrew the antenna, apply a strong adhesive on the wire head, and tighten it. The effect is very good.
(9): How to easily pass the brakes during vehicle inspection: Just unplug the control harness plug on the ABS pump and plug it in again after finishing the work. Normal use will not be affected. Take time to the repair station to eliminate the fault code.
(10): How to put things that are not commonly used in the car but must be carried: Open the trunk and look at the spare tire. There is the largest storage compartment.
(11): How to improve the air circulation and defrosting effect in the car: Replace the dust filter element (in the engine compartment) with a sponge of the same size, which not only increases the air intake, but also can be disassembled and washed for reuse. In addition, the car can be defrosted expressly in winter , You don’t need to turn on the fan when you run long distances, and save fuel at the same time.
(12): How to keep the clutch easy for a long time: Every time the brake oil is changed, the maintenance personnel should discharge the waste oil from the clutch sub-cylinder. Because the clutch and brake use the same oil storage cup, it may be difficult, but it should be done.
(13): What to do when you feel that the brakes are not as effective as before: When you wait for the red light, step on the brakes vigorously and you will see results.
On 23-26 March 2023，The Auto Maintenance and Repair Expo (AMR) will be held at the National Convention and Exhibition Center (Tianjin), bringing a professional exhibition and communication platform to the booming automobile service industry. This exhibition is expected to have an exhibition area of 100,000 square meters, which will attract more than a thousand overseas exhibitors to showcase the cutting-edge technology and products of the automotive service industry to audiences from all over the country and overseas. We look forward to your arrival.